Missing pull-up resistors on MISO? (No – SPI uses push-pull). Real Cause: You forgot to connect the CE pin to a digital output. CE must be pulled HIGH for TX mode. Many beginners leave it floating. Tie it to a terminal set to HIGH or connect it to the Arduino pin 9 as shown above.
This is where comes in.
The simulation component only provides the hardware model; you will also need the corresponding software libraries for your microcontroller (e.g., Arduino) to communicate with the module: nrf24l01 proteus library download link
The remains one of the most searched queries in embedded simulation. By following this guide, you can successfully install and use a reliable third-party library to simulate wireless projects in Proteus. Remember to always download from trusted sources like The Engineering Projects or verified GitHub repositories to avoid malware. Missing pull-up resistors on MISO
void setup() radio.begin(); radio.openWritingPipe(address); radio.setPALevel(RF24_PA_MIN); radio.stopListening(); CE must be pulled HIGH for TX mode